24V GreenergyStar Wind Turbine Charge Controller for Apollo WindZilla Ametek

Features:

1. GreenergyStar Apollo, Patriot, WindZilla Phoenix and MegaShark wind turbines
2. Compatible with GreenergyStar branded grid-tie inverters
3. System Voltage: 24V Nominal
4. Microprocessor based control electronics to control charging, outputs and dump load
5. Intuitive LED Display to reflect system status
6. Keeps battery in an optimum charged state
7. High quality finned aluminum casing to protect the interior and dissipate heat

Warning: Controller will get damaged if polarity of battery is incorrect, Dump Load must be connected at all times

Protection Features:

• Dump Load MUST be connected at all time to protect the charge controller, no dump load = no warranty
• Requires a minimum of 1.2Ohm 600W resistive load to be connected to the dump load terminal
• Dump load activates when AC Turbine is >= 35V
• Activating dump load will slow down the AC turbine and reduce voltage spikes.
• Over voltage protection: All outputs will be cut when input voltage is over 30V. However dump load will stay on.
• The DUMMY LED will turn Red when the dump load has been activated

Mechanical Specifications:

What are included:

- One Wind Turbine Charge Controller
- Instruction Manual

Warranty:

We will warrant this unit against any manufacture defects or workmanship for 1 year from the date of purchase. This limited warranty specifically excludes damage caused by improper installation, accident, misuse, abuse, improper storage, or any unauthorized disassembly, repair, or modification.This warranty is not transferable. In the event of a claim against this warranty, the seller's obligation, and the claimant's sole remedy, shall be replacement of the product, repair, or refund of the original purchase price excluding any shipping and handling fees. All shipping and handling fees going both ways are responsible by the buyer.

NO OPERATING COST
GENERATES ELECTRICITY FROM THE ABUNDANT RESOURCE - SOLAR & WIND